Network Selection
Last updated
Last updated
This documentation portal is currently undergoing updates to align with the IoTeX 2.0 Whitepaper release. Information provided here may be incomplete, or out-of-date. Please use this portal for preliminary reference only, and check out the official IoTeX 2.0 Whitepaper for updated information.
.2024 | IoTeX
The default firmware installed on Pebble Tracker wraps sensor readings in an MQTT message and sends one data message every 5 minutes to the IoTeX Real World Data Oracle Mainnet network.
Alternatively, the firmware can be configured to send the data to the testnet oracle network by following the steps below:
Enter the firmware configuration
Power on the device while pressing and keep pressing the down arrow until you see the firmware configuration menu.
Go to "System Settings"
User the up/down arrow buttons to select the "System Settings" menu item to move between menu options. Shortly press the power button to confirm the selection.
Go to "Select Region"
Go to the "Select Region" menu item and press the power button to confirm the selection.
Select the network
Select the menu item that ends by "- M" to send the data to the Mainnet network, or select the menu item that ends by "- T" to send the data to the Testnet network.
Reboot the device
Use the arrow buttons and the power button to select "Exit" in the menu until you get back to the initial menu, then select "Reboot Pebble."
You can check the currently selected network on the display when Pebble is powered on and while it's connecting to the network:
To visualize the data collected by your devices, you can use the MachineFi portal. For data sent to the mainnet Oracle network will be available on https://portal.machinefi.com. If you selected the Testnet Network on your device, you should use https://portal-testnet.machinefi.com instead.
